Features:
- Flexible simple-to-use control console, which can be positioned at convenient angle.
- Motorized machine, with sensitive electronic Load and Length Indicators.
- Length reset facility for length indicator at any position of moving platen to indicate actual deflection.
- Tare Set facility to off-set dead weights of samples, clamps, adapters, mounts, etc.
- Over-load indication by audio annunciation.
This equipment is extremely versatile for conducting Tensile Strength Test of paper, paperboard, etc. It can also be useful for testing compression and tension forces.
Following tests also can be conducted on this equipment:
- Testing of tension and compression springs.
- Insertion and pull-out force checking for connectors, plug-in PCBs, etc.
- Tensile testing of crimped terminals.
|
- Operational/Actuating force checking of electrical switches, buttons, aerosol cans, etc.
- Testing of rubbers, plastics, fibers, filaments, textiles, papers, boards, aluminum and other non-ferrous foils, etc.
- Measuring firmness of foams and sponges of polyurethane, latex, coir, polystyrene, etc.
- Testing crush strength of medicinal pills, tablets, capsules, etc.
- Flexural & Shear checking of pipes, tubes, PCBs, etc.
- Calibrate magnets.
- Peel & Adhesion Strength of stickers, labels, BOPP tapes, laminates, Adhesives, surgical tapes, etc.
- Crush/Compression strength checking for packing materials viz, paper, boards, bottles, cartons, etc.
Options:
- Increased admit between Platens.
- Plotter or digital data logger.
- Twin Load cell arrangement for sensing forces in 2 different ranges accurately.
- Range Selector for single load cell to sense forces in low range.
- Step less Variable Loading Speed on request.
- Optional Grips and Fixtures-Self-tightening Tensile Grip, Puncture Test Fixture, TW Wrapped Wire Connector Grip, Spool Grip, 90 degrees Peel Test Fixture, Flat Tensile Grip, Ring & Flat Crush Fixtures.
- Peak-hold to Instant Reading change over by simple switch operation.
Suitable for Testing as per following Standards:
| IS | 1924 (Part II) 1995 |
| TAPPI | T 494 om-01 |
| ASTM | D 828-93 |
Technical Specifications:
| Max. Admit between Platens | 300 mm |
| Minimum Admit | 50mm |
| Loading Capacity | 250 kgf |
| Load Sensing Capacity | 5 / 10 / 50 / 100 / 200 kg |
| Load Indicator Resolution | 0.2% Full Scale |
| Load Indicator Sensitivity | ± 0.4% FS |
| Length Indicator Resolution | 0.1 mm |
| Length Indicator Accuracy | ± 0.2 mm |
| Loading Speed | 12.5 mm/min. or as specified up to max. 50 mm/min (provided Load Cell capacity is more than 25 kgf) |
| Electric Supply Requirement | 1 Phase 220 V-AC 50 Htz with positive Neutral Earthing |
|
Tensile Tester For Non-Ferrous And Non-Metalic Mat
